Stinger SPXDMF ENLIGHT10 Y 8 Pack 3-Pin Harness Pack

Expand Your ENLIGHT10 Lighting Run 3-Pin Y Harness Pack for SPXD5 and SPXDUBKIT

Product Overview

The Stinger SPXDMF is an 8-pack of 3-pin Y harness connectors designed for expanding or extending lighting harness runs on compatible Stinger ENLIGHT10 products. The pack contains four male and four female solder-on connectors, along with 16 pieces of heat shrink, providing the hardware needed to add additional harness sections to SPXD5 LED strip and SPXDUBKIT installations.

This is a wiring accessory intended for use by those customising or extending their ENLIGHT10 lighting layout. It is for use with Stinger ENLIGHT10 SPXD5 and SPXDUBKIT only.

---

Key Specifications

• Manufacturer Part Number: SPXDMF
• Function: 3-pin Y harness connectors for ENLIGHT10 harness expansion
• Compatible products: Stinger ENLIGHT10 SPXD5, SPXDUBKIT
• Contents: 4x female solder-on connectors, 4x male solder-on connectors, 16x heat shrink pieces
• Total connectors: 8 (4 male + 4 female)
• Connector type: 3-pin solder-on
• Application: ENLIGHT10 harness addition and customisation

---

Features & Benefits

• Harness Expansion Made Simple — Provides the solder-on connectors and heat shrink needed to add additional ENLIGHT10 harness sections to an SPXD5 or SPXDUBKIT installation, without sourcing individual components.
• Matched Male and Female Pairs — The pack includes both male and female connectors in equal quantities (4 of each), covering the connection points needed for Y-harness splits and extensions.
• Heat Shrink Included — 16 pieces of heat shrink are supplied alongside the connectors, providing the insulation needed for clean, weatherproof solder joints without a separate hardware run.
• Customise Your Install — Enables a more flexible lighting layout by allowing additional harness branches to be added where the standard harness length or configuration doesn't reach.

---

Technical Specs

---

Compatible With / Goes Well With

• Stinger ENLIGHT10 SPXD5 LED strips
• Stinger ENLIGHT10 SPXDUBKIT

---

Frequently Asked Questions

What is the SPXDMF used for?

The SPXDMF provides 3-pin solder-on Y harness connectors and heat shrink for adding additional harness sections to Stinger ENLIGHT10 SPXD5 and SPXDUBKIT installations, allowing a more customised or extended lighting layout.

What is included in the pack?

The pack contains 4x female solder-on connectors, 4x male solder-on connectors, and 16x heat shrink pieces — a total of 8 connectors with heat shrink for insulation.

Do I need to solder to use the SPXDMF?

Yes — the SPXDMF uses solder-on connectors. Soldering is required to attach the connectors to the harness. The included heat shrink provides insulation over the solder joints for a clean, weatherproof finish.

Which ENLIGHT10 products is the SPXDMF compatible with?

The SPXDMF is confirmed for use with Stinger ENLIGHT10 SPXD5 LED strips and the SPXDUBKIT only. It is not confirmed for use with other ENLIGHT10 products.

Is the SPXDMF a plug-and-play accessory?

No — the SPXDMF requires soldering. It is a wiring accessory for those customising or extending their ENLIGHT10 harness layout, not a plug-in solution.